Before starting for the first time, first install the CR2032 battery into the motherboard slot.

Then, based on the serial number of your NVR, you need to configure the BIOS.

For all NVRs, it is important to observe the correct polarity when installing

For Neurostation and Ultrastation

Image Modified

For MiniNVR and Duostation

Image Added

Serial number of the NVR

The serial number is indicated on the sticker, which is located on the back of the recorder, on the side of the connectors.

BIOS settings

G25m1 G24m1

Press F2 to enter the BIOS.

Configure the following parameters:

Switch to Advanced Mode by pressing F6.

• Advanced \ Chipset Configuration \ Primary Graphics Adapter = Onboard
• Advanced \ Chipset Configuration \ Restore on AC Power Loss = Power ON
• Boot \ Boot Option #1 = UEFI: ASX6000LNP-128GT-C
• Boot \ Full Screen Logo = Disabled

Save settings and exit (F10 and Yes)

G8m2 G5m2

Press F2 to enter the BIOS.

Configure the following parameters:

Switch to Advanced Mode by pressing F6.

• Advanced \ Chipset Configuration \ Primary Graphics Adapter = Onboard
• Advanced \ Chipset Configuration \ Restore on AC Power Loss = Power ON
• Boot \ Boot Option #1 = UEFI: JetFlashTranscend
• Boot \ Full Screen Logo = Disabled

Save settings and exit (F10 and Yes)

E13m2

Press F2 to enter the BIOS.

Configure the following parameters:

• Setup \ Advanced \ Miscellaneous Configuration \ State After G3 – S0 State
  
• Boot \ Add Boot Options - First
  
• Boot \ EFI/Legacy Device Order - Legacy first
  
• Boot \ EFI - EFI - Configure the boot priority from Hard drive
  

Save settings and exit (F10 and Yes)

L11m1

Press F2 to enter the BIOS.

Configure the following parameters:

• Setup \ Advanced \ Miscellaneous Configuration \ State After G3 – S0 State
  
• Boot \ Add Boot Options - First
  
• Boot \ EFI/Legacy Device Order - EFI device first
  
• Boot \ EFI - Configure the boot priority from Hard Drive

Save settings and exit (F10 and Yes)

Aleksandr Savkin